Winnebago FORZA Series Manual page 44

SECTION 3 –
DRIVING YOUR MOTORHOME
Vertical Access Panel
*Model 38F shown
Rearward Engine Access Cover
Model 34T
The Rearward Engine Access Cover is
accessed by removing the screws at the head of
the bed board and setting the bed board aside.
7. Unplug the air mattress pump.
8. Remove mattress from the bed board and set
aside in another area of the motorhome.
9. Remove six screws (located on top of the
rearward bed board) and set aside.
• Remove six screws from
rearward bed board (three on
each side).
*Model 34T shown
10. Remove bed board and set aside in another
area of the motorhome.
11. Remove fasteners from metal engine cover
(rearward) and set aside to access engine.
Models 36G
The Rearward Engine Access cover is located
inside the wardrobe beneath an access cover.
3-18
• Lift access panel from wardrobe floor.
• Remove fasteners from the metal engine
cover and set aside to access engine.
Models 38F, 38W, and 38D
The Rearward Engine Access Cover is located
beneath the rear lavatory cabinet.
• Remove lavatory cabinet drawers and access
panels inside lavatory cabinet.
*Model 38W shown
• Remove fasteners from the metal engine
cover and set aside to access engine.
NOTE: Removal of the lavatory cabinet face is
required before removing the Metal
Engine Access Cover (see previous
steps).
12. Reverse steps to reinstall engine access
covers, support angle, access panels, bed
board, and lavatory cabinet face.