3.3 Installing Components
Caution!
Please make sure you follow the safety guidelines presented in
when making changes to the hardware.
Except for installing 2.5" disk drives, all component installation described in this
section require power to the unit to be shut down and removed.
3.3.1 Removing the Top Cover
Note!
You need:
- A PH2 screw driver
The top cover is secured by 5 thumb screws. To remove the top cover, loosen the
thumb screws. When unlocked, a spring inside the thumb screw will notably push the
screw head towards you.
After that, slide the top cover backwards until the front flange of the top cover
disengages with the unit's face plate, and then lift off and remove the top cover.
Caution!
Please power off the system before removing the top cover.
CAUTION: TO DISCONNECT POWER, REMOVE ALL POWER CORDS
ATTENTION: DÉBRANCHER TOUS LES CORDONS D'ALIMENTATION
警告: 電源を切るには、ユニットから電源コードをすべてつとも抜いてくださ
い。
当心: 如要切断电源, 请将所有电源线都从机器上拔掉。
注意: 若要切斷電源, 請將所有電源線都從機器上拔除。
3.3.2 Reinstalling the Top Cover
Note!
You need:
- A PH2 screw driver
____________________________________________________________________________________________________
SKY-8201L Manual V02 2018420
Figure 3-23: Slide Top Cover Back
FROM UNITS.
POUR DÉCONNECTER L'UNITÉ DU SECTEUR.
Copyright 2016 Advantech Co. Ltd. All rights reserved.
section 1.1
Page 81