Names Of The Terminals On The Rear Panel; Preparing And Using The Remote Control - Toshiba TLP-X200U Owner's Manual

Data projector xga & wxga
Hide thumbs Also See for TLP-X200U:
Table of Contents

Advertisement

Names of the terminals on the rear panel

(1)
(2)
(3)
(4)
(5)
(8)
(9)
(10)
(11)
(12)
Name
: Main Function
(1) USB terminal
: Connects a commercial USB memory device.
(2) HDMI™ terminal
: Inputs digital signals from HDMI (High-Definition
Multimedia Interface) compatible digital source.
(3) AUDIO IN terminal
: Inputs audio signals from a computer or video equipment.
(Multiple use for COMPUTER 1 IN/2 IN, VIDEO and S-
VIDEO)
(4) S-VIDEO terminal
: Inputs S video signals from video equipment.
(5) COMPUTER 1 IN (Y/P
/P
1) terminal
B
R
: Inputs analog RGB signal from a computer or a
component video signal (Y/P
(6) COMPUTER 2 IN (Y/P
/P
2) terminal/MONITOR OUT terminal
B
R
: Inputs analog RGB signal from a computer or a
component video signal (Y/P
It can also be used as MONITOR OUT terminal by the
switch of (7).
(7) Switch
: Switches between COMPUTER 2 IN and MONITOR OUT.
(8) LAN terminal
: Connects a network cable.
(9) AC IN socket
: Connects the supplied power cord here.
(10) AUDIO OUT terminal
: Outputs audio signals.
(11) VIDEO terminal
: Inputs video signals from video equipment.
(12) CONTROL terminal
: When operating the projector via a computer, connect
this to the controlling computer's RS-232C port.
(6) (7)
p.48
/P
) from video equipment.
B
R
/P
) from video equipment.
B
R
p.103
18

Preparing and using the remote control

Loading dry-cell batteries
into the remote control
Remove the battery cover.
1
Insert the dry-cell batteries.
2
Be sure to align the plus and minus
ends of the batteries properly.
Two batteries (LR03, SIZE AAA) are used.
Replace the battery cover.
3
Dry-cell batteries
Before using the batteries, be sure to observe the Safety Precautions described in
previous pages.
Remove batteries from remote control when not using for extended periods.
If the remote control stops working, or if its range decreases, replace all the batteries
with new ones. (2 batteries (LR03 SIZE AAA))
Keep the batteries away from the reach of children.
Batteries are choking hazards and can be very dangerous if swallowed. If the batteries
are swallowed, seek medical assistance immediately.
The remote control
The remote control may fail to operate if the infrared remote sensor is exposed to bright
sunlight or fluorescent lighting.
Do not drop or bang.
Do not leave in hot or humid locations.
Do not allow it to get wet or place it on top of wet objects.
Do not take it apart.
In rare cases, ambient conditions could impede the operation of the remote control. If
this happens, point the remote control at the main unit again, and repeat the operation.
Operating the remote
control
Point toward the projector's infrared
remote sensor, and press any button
on the remote control.
Operating the projector from the front
Approx.15°
Note:
When operating the remote control
from behind the projector, the infrared
signal is reflected on the projecting
surface. The operating range therefore
may decrease depending on the
shape and material of the projecting
surface.
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tlp-wx200Tlp-x200

Table of Contents