Displaying/Deleting Last Fault On Lcd Handset - Stiegelmeyer Seta pro Instruction Manual

then perform the following steps:
No.
1
2
3
After the acknowledgement procedure has been completed, the padlock symbol appears.
You can now unlock the functions you wish to release for the patient (see
ing electric adjustment functions
15.4

Displaying/deleting last fault on LCD handset

Displaying the last fault that occurred can be helpful in error analysis.
The fault messages can only be called up and deleted by service personnel.
Call up and display the last fault on the LCD handset as follows:
135
Display
Current fault, e.g.:
Additional fault, if avail-
able, or
Press the UP and DOWN buttons simultaneous-
ly and at the same time hold the top end of the
handset against the orange magnetic unlocking
key until the warning symbol
and the current fault appears (see
on LCD handset
Press Display
the but-
tons
--
»
69).
Troubleshooting
disappears
Fault display
»
132)
Description
Advance to the next view
Press both buttons until display
>RESET< Keep pressed for 5 s
until >OK !< If other faults are
present, the next fault is shown in-
stead of >OK< and must be ac-
knowledged by repeating steps
1+2
5 short signal tones until display of
> < RESET is com-
plete, all errors are acknowledged;
all functions are locked
Locking/unlock-
Instruction Manual