Manual Cleaning - Stiegelmeyer Seta pro Instruction Manual

12.2

Manual cleaning

ATTENTION
Material damage
Failure to heed this warning may result in damage to the bed.
•
Do not use scouring agents, abrasive cleaning agents or scouring pads. These substan-
ces can damage the surfaces.
•
Do not use organic solvents such as halogenated/aromatic hydrocarbons and ketones.
•
Do not use acidic cleaning agents.
•
It is essential to follow the manufacturer's dosage advice for cleaning agents and disinfec-
tants to prevent damaging the plastic and painted or surfaces!
•
It is not permitted to clean the bed using a manually operated steel jet nozzle which is, for
example, connected to a steam cleaner/high pressure cleaner. A minimum distance of 30
cm from the electrical components cannot be guaranteed in this case.
•
For non-washable beds: Avoid direct contact of the bed with splash-water. Do not use a
water hose or similar appliance to clean the bed.
•
Ensure that no liquid residues remain on any parts of the bed after cleaning or disinfec-
tion. Otherwise the surfaces in these areas may become damaged in the long term.
•
If, despite its excellent mechanical resistance, the coated surface is damaged by scratch-
es or marks which permeate the entire coating, the affected areas should be resealed us-
ing a suitable repair substance to prevent moisture from penetrating. For further informa-
tion, consult STIEGELMEYER or a specialist dealer of your choice.
•
Disinfectants based on compounds which could potentially release chlorine may be corro-
sive for metals, synthetics, rubbers and other materials over longer contact periods or
when concentrations are too high. Use these agents sparingly and only if expressly re-
quired.
Suitable cleaning and disinfection agents
For disinfection by wiping, most cleaning and disinfection agents usually used in hospitals or
care facilities can be used, such as cold and hot water, detergents, alkaline solutions and al-
cohols.
These agents must not contain any substances that could change the surface structure or
the adhesive properties of the plastic materials.
109
Cleaning and disinfection
Instruction Manual