Display Editor; Initial Operation; Maintenance And Warranty - janitza Prophi 12R Manual

Section 10 Display-Editor
The Display-editor is reached by activation the operation button.
In the Display-editor a selection of measuring values can be performed which shall be
displayed in the Display-mode.
Out of the available measuring values shown below 3 values can be selected
sequently which then are available in the Display-mode as large letters. Selection is
done by the arrow-buttons, confirmation with ENTER:
1 Grid voltage
2 Apparent current
3 Reactive power
4 Active power
5 Apparent power
6 Difference reactive power
7 Frequency
8 Temperature
9 THD-V
10 THD-I
11 Cos Phi
12 Tan Phi
13 System Clock
14 Relays / Error
15 --- (no display)
Example: Display in DISPLAY-MODE
Selected parameters:
1. Relay / Error
2. Cos Phi
3. Diff. reactive power
Note:
Even in Display-Mode the device will continue to operate as P.F.controller in the
background with all functions programmed!
Section 11

Initial operation

The controller must have been installed before being set up and operated.
All network-specific parameters are fully programmed as described in section 5
(Programming) by being entered in sequence and stored. The controller is then set to
automatic operation with the operating mode key. It is now ready for operation.
Section 12 Maintenance and warranty
The PROPHI 12 should need no maintenance if the operating conditions are observed.
However, it is recommended that a functional check of the controller be performed in
conjunction with the regular checking of the capacitor bank. In the event of any
interventions in the controller during the warranty period, all warranty claims lapse.
DISPLAY-EDITOR
------------------
1.DISPLAY [ 1]
[ DISPLAYS / ERROR]
1 2 3 4 5 6 7 8 9 10 11 12
------------------
cos
phi
------------------
Q
dif
- 20 -
Prophi 12R / 12 RS
®
A M
0.960 IND
19.5 kvar
21