Interface - janitza Prophi 12R Manual

Depending on the selected protocol the following settings may be partially deactivated:
11 BAUDRATE COM1
12 ADRESS COM1
13 Number MMI
14 Type of measuring device (MMI6000 / MMI7000 / MMI8003 / UCM-5)
15 Number of BR7000-1
16 ASCII transmit. interval
17 Separator (for ASCII )
An optional hardware-adapter „IF8000" extend the device with a 2nd interface COM2:
18 PROTOCOL COM2
19 BAUDRATE COM2
20 ADRESS COM2
21 Type of measuring device compare COM1
22 FUNCTION TI8004
23 Number of sensors [4]
24 - 36
Instructions for bus wiring when using the interface
For bus wiring screened cable has to be used!
R
The bus wirings (incoming and outgoing leads) always have to be applied directly to
R
the device (no branch boxes)!
In the devices at the end of the busses the terminating resistors integrated in the
R
device have to be activated (DIP-switch ON).
Connecting plan INTERFACE:
Switch for
terminating resistor
Baudrate 9600...256000 adjustable
Parity NONE, ODD, EVEN selectable
[1] (1...255)
[1] (1...9) Number of connected MMI
(1...4) Connected devices during cascading
[10] sec. (1-255) Repeat. time ASCII transmission
Selection HT; LF/CR; SP; CR/LF; Minus; CSV
----
MODBUS KTR
MODBUS RTU
SYNC-MODE
EXTERN
TI8004
compare COM1
compare COM1
system-, unit- or step monitoring
(1...12) compare application Ti8004
correlation step <--> sensor
Vb Vm
L N L1 N
(L3) (L2)
On INTERFACE RS 485
Gnd B A PE
Prophi
OFF
Modbus monitoring
Modbus standard protocol
compare separate application
temperature interface
Im SERVICE
k l
EXT. IN-/ OUTPUT
ext. input message-
110...230V relay
12R / 12 RS
®
23