Raven SBG Viper 4+ Service Manual

Raven SBG Viper 4+ Service Manual

Hide thumbs Also See for SBG Viper 4+:

Advertisement

CONFIGURATION MANUAL
Viper 4+ service manual

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SBG Viper 4+ and is the answer not in the manual?

Questions and answers

Summary of Contents for Raven SBG Viper 4+

  • Page 1 CONFIGURATION MANUAL Viper 4+ service manual...
  • Page 2: Table Of Contents

    Viper 4+ Service manual I V1.0 Content Remote Support......................3 Connect to internal Septentrio GPS receiver ..............5 Connect to internal Satel radio modem ................. 7 Capture screenshots on a Viper 4+ ................8 COM-Port overview ...................... 9 Viper 4+ service manual-EN-V1.0 I Pag 2/9...
  • Page 3: Remote Support

    Viper 4+ Service manual I V1.0 1. Remote Support At a Viper 4+ we use the SlingShot Portal to perform a remote support session. In the SBGuidance Loader of the Viper 4+ or in the SBGuidance software under INFO > SYSTEM >...
  • Page 4 Viper 4+ Service manual I V1.0 7. A screen like Figure 5 appears. The technical service specialist is able to take over all the functionality of the screen (similar to TeamViewer). Figure 5 Remote Support session Viper 4+ service manual-EN-V1.0 I Pag 4/9...
  • Page 5: Connect To Internal Septentrio Gps Receiver

    Viper 4+ Service manual I V1.0 2. Connect to internal Septentrio GPS receiver Take the following steps to make a serial connection to the internal Septentrio GPS receiver: 1. Connect a serial cable or USB-to-Serial converter from your desktop PC/laptop to the SUB-D9 connector with label “NMEA”...
  • Page 6 Viper 4+ Service manual I V1.0 4. Select serial connection and choose the correct COM-port (in this case COM1). If you do not know which COM-port of your computer is used, look in the Windows Device Manager. Take the following steps to do this: a.
  • Page 7: Connect To Internal Satel Radio Modem

    Viper 4+ Service manual I V1.0 3. Connect to internal Satel radio modem Take the following steps to connect with a serial connection to the internal Satel radio modem: 1. Connect a serial cable or USB-to-Serial converter from your desktop PC/laptop to the SUB-D9 connector with label “RTK- COR”...
  • Page 8: Capture Screenshots On A Viper 4

    Viper 4+ Service manual I V1.0 4. Capture screenshots on a Viper 4+ On a Viper 4+ it is not possibe to use an external screenshot program, like we can use on a Viper 4 or GeoStar (for example FsCapture). Therefore, to capture a screenshot on a Viper 4+ (only possible in SBGuidance), take the following steps: Figure 14 Capture screenshot...
  • Page 9: Com-Port Overview

    Viper 4+ Service manual I V1.0 5. COM-Port overview In the Viper 4+ in some setup screens the COM-ports are named in a different way compared to the Viper 4 and GeoStar. This is for example noticeable in the GPS receiver setup wizard in the SBGuidance Configurator (Figure 17Figure 17).

Table of Contents