The Battery Replacement; Battery Precaution - Bestway SaluSpa BW54299 Owner's Manual

After the GFCI Test, press the "RESET" button , then press the pump
then the indicator start to flash , pump has entered the matching condition.
2. Press the button for 3 seconds on remote control , the LED display on remote control will appear "PIR",
remote controller has entered the matching condition. If LED display appear "PAS" , means finish connection.
NOTE:1.When the remote control or pump into the matching condition, only 20 seconds matching time,
matching will fail over time, You need to follow the steps above to match.
3. When the pump and the remote control matching conditions at the same time, the matching will be successful.
4.
The remote controller matching is successful, First of all, you need to open the
NOTE: The distauce of remote control is less the 10m.
WARNING !
Do not put the Remote
Control in the water, if the remote
control falls into water, take it
out of the water immediately.
Damage to the remote control caused
by immersion in the water is not covered under your
warranty.

The battery replacement

Battery Precaution

・Do not mix old and new batteries.
・Do not mix the different types of batteries. Do not mix alkaline, standard (Carbon - Zinc), or rechargeable (Nickel - Cadmium) batteries.
・Ensure batteries are installed correctly with regard to polarity (+ and -).
・Do not short-circuit the battery.
・Never attempt to recharge primary batteries as this may cause leakage, fire, or explosion.
・Rechargeable batteries are to be removed from this product before being charged.
・Never attempt to disassemble or open batteries as this can lead to electrolyte burns.
・Remove batteries from equipment which is not to be used for an extended period of time.
・Exhausted batteries are to be removed from this product.
・Do not dispose of product and its batteries in fire. Check your local regulations for proper disposal instructions.
・Batteries shall not be exposed to excessive heat such as sunshine, fire or the similar.
・Keep batteries out of the reach of children.
・Only use 2x CR2032 batteries.
ON/OFF
button on the control panel for 3 seconds,
button, Then you can start to use