Control Panel; Messages; Maintenance; Maintaining Spa Water - Bestway Lay-Z-Spa 54113 Monaco Owner's Manual

Messages

Problem
All the lights on the
control panel turn off,
and the pump beeps out
a warning noise

MAINTENANCE

Maintaining Spa Water

The spa owner must regularly maintain pool water, daily
if necessary. Proper water maintenance disinfects spa
water killing harmful microorganisms, removes oils,
make-up and lotion ensuring the water is clean and
safe.
Spa water quality can be extremely hazardous to your
health. We recommend the following:
For Filter Cartridge Cleaning /
Replacement
NOTE: To ensure you help your spa water stay clean,
please check and clean your filter cartridge every day if
required and we recommend you change your filter
cartridge every three days depending on use.
1. Unplug the pump.
2. Remove the filter set from the spa.
3. The filter cartridge can be rinsed-off with a garden hose and reused. However, if the filter cartridge remains soiled and discolored
the filter cartridge should be replaced. It is recommended to replace filter cartridge every three days depending on use.
4. Replace the filter set in the spa.

For Water Balance

1. As a guide, the water should be changed about every 3 days. This is only a guide; water quality is influenced by frequency of use,
persons using the spa and general maintenance.
2. Chemical maintenance: use pool chemicals to maintain water chemistry
Use pool chemicals to maintain water chemistry and chlorine or bromine tablets (do not use granules) with the chemical floater. Be
sure to consult your local pool chemical supplier for information on treating the water in your spa and information on using the
chemical tablets.
Causes
Water flow issue
No water flow
Water temperature too low
Water temperature too high
There could be a permanent
error with your pump
The test function has failed
After 72 hours of operation,
the pump will hibernate and
the rapid heating and water
filtration functions are
disabled. will appear
on your display.
The test button may have
been pressed.
Solutions
Unplug the unit and plug it back in. (If this does not solve the problem,
please contact your local Bestway Aftersales Service.)
If the adapters of the pump & the spa are blocked or the filter cartridge is
too dirty. Replace the filter cartridge if necessary. (If this does not solve the
problem, please contact your local Bestway Aftersales Service.)
If the ambient temperature is below 4ºC we recommend not to
use the spa or pump.
Unplug the pump. When the water has cooled down restart your pump (If
this does not solve the problem please contact your local Bestway
Aftersales Service.)
Consult your local Bestway Aftersales Service.
Unplug the unit and then plug back into your electrical source and retest. (If
this does not solve the problem do not use pump please contact your local
Bestway Aftersales Service.)
To re-active the pump press lock/unlock button for 3 seconds.
Unplug and then plug the pump back in to restart the system. (If this does
not solve the problem, please contact your local Bestway Aftersales
Service.)
CAUTION: YOU MUST ENSURE THE PUMP IS UNPLUGGED
BEFORE BEGINNING SPA MAINTENANCE TO AVOID RISK OF
INJURY OR DEATH.
8
Filter Cartridge
P6575
Stopper Cap
P6600
Filter Set
58239(VI)
S-S-001409