Using The Applications Card As An Independent Application Server - Aastra CPU2-S Installation Manual

Using the applications card as an independent application server

2. Either connect the monitor, keyboard and mouse directly to the applications
card or establish a remote desktop connection.
3. Log on with the user name
installing.
4. Install the customer's own applications.
Using the applications card as an independent applica-
tion server
You want to use the applications card exclusively for the customer's own applica-
tions. Please note the following:
• The pre-installed Aastra 400 applications must be completely de-installed. The
de-installation of individual components is not permitted.
• You can use an operating system of your choice or the pre-installed operating
system. You are responsible for any licensing issues when using a different oper-
ating system.
• An image of the factory installation is located on a hidden partition so that the
factory settings can be reset when necessary. Avoid the repartitioning of the ap-
plications card so that the hidden partition is not destroyed.
• WebAdmin can no longer be used for administration of the applications card. (If
you try to open a multimedia view in WebAdmin, then an error message is dis-
played).
• The customer can no longer assert any guarantee or warranty claims at Aastra
for the installed software.
Proceed as follows to install an applications card which you want to use exclusively
for the customer's own applications:
1. Install the applications card according the instructions under
plications card", Seite 11
2. Connect the LAN socket of the applications card front panel to the IP network.
3. Put the system into operation according to the instructions under
plications card in operation", Seite
4. Open WebAdmin and navigate to the
5. Either connect the monitor, keyboard and mouse directly to the applications
card or establish a remote desktop connection. The IP address for the remote
Applications card CPU2-S
syd-0500/1.2 – R3.0 SP1 – 04.2014
Administrator and with the password specified when
11.
Configuration
"Installing the ap-
"Take the ap-
/ IP network view.
29