Table of Contents
Advertisement
About Aastra
Configuring the applications card
Configure the applications card by executing the configuration processes in
the following order:
you can configure the OIP application. To secure the configuration data, cre-
ate a backup in the end.
Settings under
Basic configuration
The general settings are described below.
Basic configuration
Parameter
Name sequence (as entered in
the communication server)
IP address
Communication servers in sub-
net
Current password
New password
Windows work group settings
CTI server configuration portals
Settings under
IP Network
You will find the IP network settings here.
14
Basic
configuration,
Explanation
Define the order of first name and surname here. The setting is applied to all
applications of the applications card. Select the same order as defined in the
communication server's phone books.
Note:
Perform this setting at the beginning of the configuration process and, if pos-
sible, do not modify the setting in a fully configured system.
IP address of the communication server If the wrong IP address is entered, the
set up assistant has probably detected other communication servers on your
subnet. You can see all the IP addresses of detected communication servers
under
Communication servers in
communication server and click the
List of the IP addresses of all detected communications servers on the subnet.
To use any of the IP addresses, click the
The applications card current password used for the Windows operating sys-
tem as well as on the installed OIP application.
The new password of the applications card is automatically applied for the
Windows operating system on the applications card and for the installed and
OIP applications. To change the password may takes several minutes.
These settings are relevant only if the applications card is to be integrated
into a Windows work group.
Note:
The applications card can be used in a domain environment, but should not
be a member of a domain.
This section contains a link to the OIP Toolbox, which is the OIP configuration
console. Log on using the user name
password.
IP Network
and Licenses. After that
subnet. Select the IP address of the correct
<<
button to apply it.
<<
button.
cpu2-emmc
and the applications card
Applications card CPU2-S
syd-0500/1.2 – R3.0 SP1 – 04.2014
Advertisement
Table of Contents
