Table of Contents
Advertisement
Replacing an applications card
6. Select the update package you want and click the
The applications card analyses the data in the update package and displays in-
formation on the new software. This may take a while.
7. Check the software versions and install the update package by clicking the
stall
button.
Once the installation is completed, the applications card is restarted and the
Maintenance
is displayed once again. The new software is now active.
Replacing an applications card
To replace an applications card, proceed as follows:
1. Shut down the installed applications card, by pressing the on/off push button
on the front side of the card.
2. Switch off the communication server and remove the applications card.
3. Switch on the communication server again.
4. From your administration PC, open your communication server's WebAdmin
and log on.
5. Navigate up to the card view
click the Deletebutton at the end of the slot 2.
6. Install the new applications card and start it up following the instructions
stalling the applications card"
Reset applications card to factory settings
You can reset the applications card to the factory settings. This is recom-
mended if you wish to use the applications card on another communication
server with a different configuration, for example.
Reset the applications card with WebAdmin (recommendation)
To restore the applications card to the factory settings with WebAdmin proceed as
follows:
Warning:
When resetting the applications card, all data saved on the card is lost.
1. If required create a backup of your current configuration data according to the
indications in
"Saving the configuration (menu Maintenance)", Seite
24
(Configuration
/
System
on page 11.
Unzip
button.
/
Cards and modules
16.
Applications card CPU2-S
syd-0500/1.2 – R3.0 SP1 – 04.2014
In-
and
"In-
Advertisement
Table of Contents
