Roland Juno-D Instructions page 2

R
1. In the MODE section, press PATCH.
2. Press one of the ten category buttons (0-9) to select a family of sounds.
+ / -
3. Use the
4. Press AUDITION in the MODE section and the JUNO-D will demo the patch for
you. Press the AUDITION button to stop the JUNO-D.
5. You can also modify the sounds in real-time by using the PATCH MODIFY knobs
on the right side of the JUNO-D.
1. Make sure that you are in PATCH mode.
2. On the right side of the JUNO-D, press the KEY MODE button until SPLIT is lit.
3. Press the PARAM button in the EDIT Section.
4. Press the DESTINATION TONE button in PATCH MODIFY until "UPPER" is lit.
5. Press the NUMERIC button and use the category buttons to choose patch "025"
(Touch EP). Press the ENTER button.
6. Press the DESTINATION TONE button in PATCH MODIFY until "LOWER" is lit.
7. Press the NUMERIC button and use the category buttons to choose patch "200"
(Low Bass). Press the ENTER button.
8. Press EXIT to hear the Bass in the left hand and the EP in the right.
Show the Chord Memory and Phrase/Arpeggiator
1. Keep the JUNO-D in Split Mode and press the CHORD MEMORY button.
2. Play any single note and the JUNO-D it will play a full chord.
3. Press the PHRASE/ARPEGGIO button.
4. Press category button #1. Play a note (Middle C). The JUNO-D will use both the
Chord Memory and Arpeggio function to play a phrase.
5. To try different phrases, press any one of the ten category buttons (0-9).
1. In the MODE section, press the PERFORM button.
2. Use the category buttons to select performance, "P06 JUNO-D EP".
3. Press the RHYTHM GUIDE button.
4. Play a note (Middle C). The JUNO-D will now play the currently selected
Phrase/Arpeggiation and Rhythm Groove in time with each other.
5. Press RHYTHM/GUIDE to stop the rhythm function from playing.
Juno-D Synthesizer
Show the Cool Sounds
Value Buttons to select a sound in that category.
Show How to Create Splits and Layer Sounds
Show the Rhythm Guide Feature
Stuff To Show