ESP GuardCam LED Manual page 5

Installing GuardCam LED
1 . Place plastic masonry plugs into desired surface aligning holes as shown below . Using
an electric screwdriver, fasten mounting plate directly to surface using screws .
2 . Feed the cable through the back mounting box and bush the cable entry to avoid
abrasion to the cable .
3 . Wire the unit as follows: (Ensure all wires are connected securely and that no loose
strands are exposed)
4 . Make sure the polarity is correct . Double check the connections after wiring . Errors may
damage the motion sensor or cause a fire hazard .
5 . Attach the unit to the mounting plate . You will first need to angle the unit back so that
the catch at the top of the mounting plate fits into slot on the back of the unit . Next
lower the unit until holes at the bottom of the mounting plate and unit are flush . Then
screw (screw A) into this hole, tightening carefully .
Please allow 1 minute warm-up time after switching on .
* Push the RESET button after switching on .
5