Taiwan - Nvidia Jetson TX1 User Manual

This transmitter module is authorized only for use in device where the antenna may be installed such that 20 cm
may be maintained between the antenna and users. The final end product must be labeled in a visible area with
the following: "Contains transmitter module IC: 2461N-NVTX11697".
Contient le module d'émission IC: 2461N-NVTX11697
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20cm is maintained between the antenna and users, and
2) The transmitter module may not be co-located with any other transmitter or antenna.
Cet appareil est conçu uniquement pour les intégrateurs OEM dans les conditions suivantes: (Pour utilisation de
dispositif module)
1) L'antenne doit être installée de telle sorte qu'une distance de 20cm est respectée entre l'antenne et les
utilisateurs, et
2) Le module émetteur peut ne pas être coïmplanté avec un autre émetteur ou antenne.
Modular OEM Integrator Notice
IMPORTANT NOTE for OEM integrator:
This module is intended for OEM integrator.
The OEM integrator is still responsible for
1. ensuring that the end-user has no manual instructions to remove or install module
2. the ISED compliance requirement of the end product, which integrates this module.
3. Appropriate measurements and if applicable additional equipment authorizations of the host device to be
addressed by the integrator/manufacturer.
4. The separate approval is required for all other operating configurations, including portable configurations and
different antenna configurations

Taiwan

National Communications Commission
國家通訊傳播委員會
CCXXxxLPyyyZz
注意！
依據 低功率電波輻射性電機管理辦法
Jetson | Copyright © 2014 NVIDIA Corporation. All rights reserved.
Jetson TX1 Developer Kit
User Guide
Page 24 of 27