Nvidia Jetson TX1 User Manual page 21

The OEM integrator is still responsible for
1. ensuring that the end-user has no manual instructions to remove or install module
2. the FCC compliance requirement of the end product, which integrates this module.
3. Appropriate measurements (e.g. 15 B compliance) and if applicable additional equipment authorizations (e.g.
Verification, Doc) of the host device to be addressed by the integrator/manufacturer.
4. The separate approval is required for all other operating configurations, including portable configurations with
respect to Part 2.1093 and different antenna configurations
Guidance to the Host Manufacturer:
We hereby acknowledge our responsibility to provide guidance to the host manufacturer in the event that
they require assistance for ensuring compliance with the Part 15 Subpart B requirements.
The user manual of the end product should include
1. Any changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate this equipment.
2. the restriction of operating this device in indoor could void the user's authority to operate the equipment.
3. This device and its antenna(s) must not be co-located or operating in conjunction with any other antenna or
transmitter.
4. This equipment should be installed and operated with minimum distance 20cm between the radiator & your
body.
5. The FCC part 15.19 statement: This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Label of the end product:
The final end product must be labeled in a visible area with the following " Contains TX FCC ID: LDKNVTX11697
".
The end product shall bear the following 15.19 statement: This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
If the labelling area is considered too small and therefore it is impractical (smaller than the palm of the hand)
to display the compliance statement, then the statement may be placed in the user manual or product
packaging.
Underwriters Laboratories (UL)
UL Listed Product Logo for Jetson TX1 Developer Kit, model name P2597.
I.T.E E204896
UL Recognized Component Logo for Embedded System Module, model name P2180.
Jetson | Copyright © 2014 NVIDIA Corporation. All rights reserved.
Jetson TX1 Developer Kit
User Guide
Page 21 of 27