International Symbols - Proluxe Impact X1 Operation Manual

International Symbols

Power On/Off
Preventative Maintenance Suggestions
The Doughpro DP3300 machines are
relatively maintenance free. For a long
and trouble-free life, the following
preventative maintenance should be
followed:
Daily Care:
1. Teflon coated platens: These
platens should only be cleaned
with mild soap and warm water
then wiped off with a clean, soft
cloth or soft sponge. Never use
steel wool or harsh abrasives or
you will cause costly damage.
*For DP3300M models*
Note that the top plate of the
lower platen is removable
without tools, for cleaning
purposes. To remove, simply
rotate the platen to the full open
position and remove the top
plate.
2. All other exterior surfaces:
Here again a daily wipe down
with mild soap and warm water
will do the job quite nicely.
Never use steel wool or harsh
abrasives or you will cause
costly damage.
Monthly Care:
Piston maintenance: The piston is the
one moving part that requires a grease
injection every two (2) to three (3)
months. A grease port located on the
right side of the upper platen piston is
provided for this purpose. Using a
standard grease gun fitted with an
extension, squeeze a food approved,
high temperature grease into the grease
port. *2 full squeezes from grease gun.
Service Problems:
Contact our factory or approved service
agency (U.S. only). Note: When
contacting factory for information, parts
or service instructions, it is of the utmost
importance that the serial number of the
machine be provided. This number can
be found on the serial plate located on
the rear of the machine.
-6- DP3300 1410/20003/40002 5/03