Firewall Configuration - FLIR Screen-EST Kiosk User Manual

11
Description — FLIR Screen-EST Kiosk
To open the camera web interface, do the following:
1. Start the FLIR IP Config software by double-tapping the desktop icon.
Note If a Windows Defender Firewall message is displayed, select to Allow access
for FLIR IP Config.
2. The FLIR IP Config automatically scans for cameras. When a camera is detected,
FLIR IP Config displays the IP address of the camera.
3. Double-tap the camera in FLIR IP Config. This opens the camera login page in a web
browser.
Note If FLIR IP Config finds several cameras, you can identify your camera by the
MAC address printed on a label at the back of the camera (see section 11.3 Camera
connectors and buttons).
4. Log in with the username admin and the default administrator password available on
the camera calibration certificate. This displays the web interface of the camera.

11.2.3 Firewall configuration

The camera is pre-configured to open up the firewall. If the camera has been reset to fac-
tory default settings, you must configure the firewall settings.
To configure the firewall settings, do the following:
1. Log in to the camera web interface, see section 11.2.2 Open the camera web
interface.
2. Go to the Administration tab and select Firewall.
3. Make sure the RTSP switch is set to ON.
4. Make sure the FLIRRESOURCE switch is set to ON.
5. Tap Apply at the bottom of the page.
#T810570; r. AA/72255/72255; en-US
45