Table of Contents
Advertisement
7
Description — Screening station
2. Screening position.
It is important to clearly mark where the person shall stand for the screening. This is
called the screening position. The face of the screened person should be at the cen-
ter of the screening position.
The screening position shall be perpendicular to the FLIR Screen-EST Kiosk camera,
so that the screened person directly faces the camera. The distance from the foot of
the FLIR Screen-EST Kiosk stand to the center of the screening position shall be 120
cm (47 in.).
Explanation:
• For accurate temperature measurements, it is important that the thermal camera
focus is correct. With a fixed screening position, the focus can be adjusted once
and for all during the setup of the screening station (no need to adjust the focus
for every screened person).
3. Queueing system, e.g. barriers and arrow floor stickers.
The queueing system will guide the visitors into the screening station, to the correct
screening position, and out of the screening station. A recommended standard is to
keep the queue at least 90 cm (36 in.) wide. To make sure people do not cut the cor-
ner and end up too close to the FLIR Screen-EST Kiosk, about 45 cm (18 in.) should
be added to the barrier leading in to the screening station.
4. Optional: Backdrop.
The camera should only see the screened person, no other people in the back-
ground. This can be achieved by placing a backdrop behind the screening position.
Additional, not in the figure:
• Optional: Operator display.
Secondary display placed near the operator for monitoring.
• Optional: Information roll-up.
Roll-up that informs people what the screening is about and why they need to do it.
• Optional: Instruction roll-up.
Roll-up that tells people to remove eyeglasses before they are screened.
7.3 Screening station considerations
For accurate screening results and an efficient screening flow, the following factors re-
lated to the screening station area should be considered.
Screening accuracy
• Screening is best with room temperatures maintained below 24°C (76°F) and relative
humidity below 50 %.
• Screening should be carried out in an area with no air movement, out of direct sun-
light, and away from heat sources.
• Avoid locations with reflective backgrounds (e.g. windows, glass doors, or metallic
surfaces).
Equipment
• The FLIR Screen-EST Kiosk is intended for indoor use.
• The FLIR Screen-EST Kiosk shall preferably be placed so that the operator can see
the screening station and be of guidance to the screened persons.
• It can be useful to have a secondary display for the operator, e.g. on the reception
desk.
• Power outlets are needed for the FLIR Screen-EST Kiosk and any operator display.
• Avoid reflections in the tablet screen. Otherwise, it can be difficult for the visitors to
see the graphics and messages on the screen.
#T810570; r. AA/72255/72255; en-US
22
Advertisement
Table of Contents
