Dimensions And Layouts - Honeywell CN100 Planning And Installation Manual

Chapter 4 - CN100 Platform Installation

Dimensions and Layouts

20
ATTENTION: ESD HAZARD
Electrostatic discharge can damage integrated circuits or
semiconductors if you touch connector pins or tracks on a
printed wiring board.
Touch a grounded object to eliminate static electricity
l
Wear an approved anti-static wrist strap
l
Do not touch the wire connectors or connector pins
l
Do not touch circuit components inside a component
l
Use a static-safe workstation if available
l
Leave the component in its static shielding box or bag until
l
they are ready for installation.
ATTENTION: Unless the location is known to be non-hazardous,
do not:
Connect or disconnect cables
l
Install or remove components
l
While the control system is powered.
ATTENTION: A moins que vous soyez dans une zone
d'atmosphère non explosive, ne pas:
Connecter or déconnecter les câbles
l
Installer or retirer des composants du système
l
Lorsque le système de contrôle est sous tension.
In this section:
Dimensions of Redundant CN100 Controller
Installation Dimensions for a Redundant Controller
21
23