Configuring Isdn - 3Com SuperStack II REMOTE ACCESS SYSTEM 1500 Getting Started Manual

4-6 C 4: U
HAPTER SING THE

Configuring ISDN

CLI C RAS 1500
TO ONFIGURE THE
Once you have peformed the basic RAS 1500 configuration, configure
RAS 1500 for ISDN. See "Using the I-Team" in Appendix A, Configuration
Assistance, for more information about ordering ISDN service.
See "Accessing the CLI Locally", earlier in this chapter, to connect to the
Console Port.
Use the following steps to configure RAS 1500 for ISDN:
If the switch type = NI - 1 (U.S. only), you need to specify Service Profile
Identifiers (SPIDs). If a different switch type is being configured, proceed
to Step 2.
1 Set up the Service Profile Identifiers (SPIDs):
set imod int rm0/slot:1/mod:1 at at*s1=[10 digit SPID]
set imod int rm0/slot:1/mod:1 at at*s2=[10 digit SPID]
You can set the SPIDs on modem channel one (rm0/slot:1/mod:1) or
modem channel two (rm0/slot:1/mod:2); RAS 1500 applies the settings to
both channels.
2 Set up the Directory Numbers (DNs) if applicable:
set imod int rm0/slot:1/mod:1 at at*p1=[7 digit DN]
set imod int rm0/slot:1/mod:1 at at*p2=[7 digit DN]