Starting The Setup Wizard - 3Com SuperStack II REMOTE ACCESS SYSTEM 1500 Getting Started Manual

3-6 C 3: U
HAPTER SING
Starting the Setup
Wizard
TRAM C RAS 1500
TO ONFIGURE THE
The Setup Wizard starts automatically for an unconfigured device and
can be run at any time for a configured device.
To start a Setup Wizard for a device:
1 In the Device Tree, double-click the device you want to configure. A
window containing a graphical representation of the device appears.
2 Select the module.
3 Right-click, then click Configure, then
Wizard. The Setup Wizard for the device starts. The Setup Wizard guides
you through the configuration of the RAS 1500.
Once you have completed the Setup Wizard, an image of the RAS 1500
appears in the right window. If any RAS 1500 Expansion units are
attached to the RAS 1500, they are displayed in the same window as the
RAS 1500 (as in the following illustration).
From this image, you can further configure your RAS 1500 and RAS 1500
Expansion units. Refer to the next section.
<the object's name>
, then Setup