Toro Z Master 8000 Series Operator's Manual page 60

Figure 78
1. Spring anchor pin under console
2. Secure springs with a washer and hairpin cotter
3. Slide the spring onto the spring-anchor pin
5. Remove the spring from the spring anchor.
Repeat for other side of the machine.
6. Unlatch the mower deck from the raised position
and slowly lower the mower deck to ground;
refer to Lowering the Mower Deck to the
Operating Position (page
Note:
The mower deck becomes heavier when
you remove the springs from the anchors. Lower
the mower deck carefully.
7. Remove the lynch pins at the front of the push
arms on both sides of the machine
g006788
16).
(Figure 79).
1. Push arm
2. Lynch pin
3. Push-arm tube
8. Loosen the bolts attached to the rubber guard
(Figure 80).
1. Bolts
2. Rubber guard
9. Unlatch the seat and disconnect the drive shaft
using the quick coupler at the jackshaft
81). Refer to Unlatching the Seat (page 19)
60
Figure 79
Figure 80
g233982
g036545
(Figure