Toro Z Master 8000 Series Operator's Manual page 30

Maintenance Service
Interval
Every 160 hours
Every 200 hours
Every 250 hours
Every 400 hours
Every 500 hours
Every 2,000 hours
Monthly
Yearly
Yearly or before storage
Important:
Refer to your engine owner's manual for additional maintenance procedures.
CAUTION
If you leave the key in the switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Shut off the engine and remove the key from the switch before you perform any maintenance.
Maintenance Procedure
• Lubricate the brake-handle pivot.
• Lubricating the brake-rod bushings and steering linkage rod ends.
• Change the engine-oil filter (more often in dirty or dusty conditions).
• Check the spark plug(s).
• Replace the fuel filter (more often in dirty or dusty conditions).
• Service or replace the air-cleaner foam element (more often under dusty, dirty
conditions).
• Change the hydraulic filter and reservoir hydraulic fluid when using Mobil® 1 fluid
(more often in dirty or dusty conditions).
• Grease the caster pivots (more often in dirty or dusty conditions).
• Replace the air-cleaner paper element (more often under dusty, dirty conditions).
• Replace the spark plug(s).
• Check the wheel lug-nut torque.
• Check the wheel-hub nut torque.
• Adjust the caster-pivot bearings.
• Check the parking-brake adjustment.
• Change the hydraulic filter and reservoir hydraulic fluid when using Toro®
HYPR-OIL™ 500 hydraulic fluid (more often in dirty or dusty conditions).
• Change the oil in all 3 gearbox housings and add oil as needed.
• Check the battery.
• Grease the PTO-belt idler arm (more often in dirty or dusty conditions).
• Grease the pump-belt idler arm (more often in dirty or dusty conditions).
• Repack the caster-wheel bearings (more often in dirty or dusty conditions).
• Grease the rear caster wheel hubs (more often in dirty or dusty conditions).
• Paint chipped surfaces.
• Check all maintenance procedures listed above before storage.
30