Safety - Toro Top Dresser 1800 Operator's Manual

Safety

Before Operating
Read and understand the contents of this Operator's
Manual before operating the machine. Become familiar
with all controls and know how to stop quickly.
Never allow children to operate the machine. Do not
allow adults to operate the machine without proper
instructions. Only trained and authorized persons should
operate this vehicle. Anyone who operates the vehicle
should have a motor vehicle license.
Never operate the machine when under the influence of
drugs or alcohol.
Keep all shields and safety devices in place. If a shield,
safety device or decal is illegible or damaged, repair or
replace it before operation is commenced.
Note: The front 1/3 area of the Workman cargo zone must
be covered by a 1/3 attachment or shield when using the
Topdresser 1800.
Tighten any loose nuts, bolts and screws to assure
machine is in safe operating condition. Make sure
Topdresser mounting pins, pivot pins and hydraulic
cylinder pins are in place and secure.
Do not modify this equipment in any manner.
Do not operate machine while wearing sandals, tennis
shoes, sneakers or shorts. Also, do not wear loose fitting
clothing which could get caught in moving parts.
Always wear long pants and substantial shoes. Wearing
safety glasses, safety shoes and a helmet is advisable
and required by some local ordinances and insurance
regulations.
While Operating
Do not run the engine in a confined area without
adequate ventilation. Exhaust fumes are hazardous and
could possibly be deadly.
This vehicle is designed to carry only You, the operator
and one passenger in the seat provided by the
manufacturer. NEVER carry passengers on the machine
and keep everyone away from the areas of operation.
Make sure all hydraulic fittings are tight and all
hydraulic hoses are in good condition before operating
this unit.
Keep hands and feet out of hopper when unit is
operating or engine is running on vehicle.
Operator and passenger should remain seated whenever
the vehicle is in motion.
Using the machine demands attention. Failure to
operate vehicle safely may result in an accident, tipover
of vehicle and serious injury or death. Drive carefully.
To prevent tipping or loss of control:
Use extreme caution, reduce speed and maintain a
safe distance around sand traps, ditches, creeks,
ramps, any unfamiliar areas or other hazards.
Watch for holes or other hidden hazards.
Use caution when operating vehicle on a steep
slope. Normally travel straight up and down slopes.
Reduce speed when making sharp turns or when
turning on hillsides. Avoid turning on hillsides
whenever possible.
Use extra caution when operating vehicle on wet
surfaces, at higher speeds or with a full load.
Stopping time will increase with a full load. Shift
into a lower gear before starting up or down a hill
Avoid sudden stops and starts. Do not go from
reverse to forward or forward to reverse without
coming to a complete stop.
Do not attempt sharp turns or abrupt maneuvers or
other unsafe driving actions that may cause a loss of
vehicle control.
Before backing up, look to the rear and assure no
one is behind. Back up slowly.
Watch out for traffic when near or crossing roads.
Always yield the right of way to pedestrians and
other vehicles. This vehicle is not designed for use
on streets or highways. Always signal your turns or
stop early enough so other persons know what you
plan to do. Obey all traffic rules and regulations.
Always watch out for and avoid low over–hangs
such as tree limbs, door jambs, over–head
walkways, etc. Make sure there is enough room over
head to easily clear the vehicle and your head.
If ever unsure about safe operation, STOP WORK
and ask your supervisor.
When loading with sand, distribute load evenly. Operate
vehicle with extra caution when the hopper is full of
sand. Keep load balanced to prevent it from shifting.
Maintenance
Before servicing or making adjustments to the
topdresser, stop engine of Workman, set parking brake
and remove key from engine to prevent accidental
starting of the engine.
Perform only those maintenance instructions described
in this manual. If major repairs are ever needed or
assistance is desired, contact an Authorized TORO
Distributor.
3