Toro Top Dresser 1800 Operator's Manual page 10

1
1. Topdresser mounting tab
2. Spacer mount
Connect Lift Cylinders
1. Secure each lift cylinder rod end to topdresser base with
a cylinder pin.
2. Secure each cylinder pin to topdresser base with a
1/4–20 x 3/4" lg. capscrew, flatwasher and nut
(FIg. 10).
2
1
1. Cylinder rod
2. Cylinder pin
Important Always unlock the Dump Stop lever before
attempting to attach the cylinder for tilting. Use the tilt of
the cylinders only for service of the engine or hydraulics
underneath.
Important
DO NOT rely on the cylinders to hold up
the topdresser. ALWAYS block the topdresser up before
going underneath to perform any type of service.
When tilting the hopper of the topdresser
back to perform maintenance on the
Workman.
Safety Support
2
ALWAYS use the safety supports supplied with the
Workman to keep the cylinders in the extended position
while performing maintenance.
1. Push safety support onto cylinder rod, making sure
2. Always install or remove safety support from outside of
3. Do not try to lower topdresser with safety safety
Connect Hydraulic Couplers
1. Place the Workman Remote Hydraulic Valve Handle of
1
2. Clean dirt from quick couplers (Fig. 12) before
10
Caution
ALWAYS remove the front mounting bolts
first.
ALWAYS tilt the topdresser with an empty
load
support end tabs rest on end of cylinder barrel and on
cylinder rod end.
topdresser.
support on cylinder.
the in the float position.
1
1. Hydraulic valve handle
connecting. Dirty couplers can introduce contamination
to the system. After cleaning, attach both quick couplers
on the topdresser to the Workman. The hoses are