Toro Top Dresser 1800 Operator's Manual page 11

marked "A" and "B", match them to the quick couplers
when installing. Assure both quick couplers are full
engaged.
1
2
1. Coupler "A"
2. Coupler "B"
Important
The Workman hydraulic system operates
on Dexron II automatic transmission fluid. This fluid
provides gear and bearing lubrication as well as fluid
for operating the hydraulic system.
When the remote hydraulic system quick couplers are
connected, hydraulic fluid flows from the topdresser to
the vehicle. If the hydraulic fluid in the topdresser is not
the same or equivalent to vehicle's, component damage
to transaxle or hydraulic system may result.
Fluid compatibility should be checked and appropriate
action taken, if topdresser is subsequently used in
conjunction with any other product using fluids other
than Dexron II ATF.
Caution
Hydraulic fluid escaping under pressure can
have sufficient force to penetrate skin and do
serious damage. Care must be used when
connecting or disconnecting hydraulic
couplers. Stop engine, apply parking brake
and place remote hydraulic valve in float
detent position to relieve hydraulic pressure
before connecting or disconnecting quick
couplers.
Important Check hydraulic oil level after installation
of Topdresser 1800. Check operation of topdresser, then
recheck hydraulic oil level. Operation of vehicle with low
oil level can damage pump, remote hydraulics, power
steering and vehicle transaxle. Use Dexron II automatic
transmission fluid if needed.
1. Start vehicle engine and test rotation of the conveyor
and brush. Place remote hydraulics lever of Workman in
the "run" position. The rotation should be as shown in
figure 13. If the rotation is backwards the quick
couplers need to be reversed.
Important Make sure hoses are routed away from any
moving, sharp or hot components.
2. Visually inspect the hydraulic system for leaks, loose
fasteners, missing parts, improperly routed lines. Make
all repairs before operating.
11
ROTATION
DIRECTION