Toro Top Dresser 1800 Operator's Manual page 16

3. Rotate motor and sprocket assembly, in mounting slots,
until proper tension is achieved.
1. Drive chain
2. Motor & sprocket assembly
4. Tighten mounting bolts.
5. Install cover, spacer and finger guard.
Adjusting Conveyor Belt
When conveyor belt is adjusted properly, the compressed
length of each compression spring should be 4-7/16 (112
mm). Adjust conveyor belt as follows:
1. Loosen jam nuts and adjust tension rod nuts to attain
desired tension.
1
4
3
1. Tension rod
2. Compression spring
3. Jam nut
4. Nut
2. Tighten jam nuts to lock adjustment.
3. Check to insure that the center distance between
conveyor belt roller shafts (Fig. 22), on each side of
machine, are equal distance (approximately 35-1/4 ).
2
1
2
4-7/16"
35-1/4,
1
1. Conveyor belt roller shafts
Replacing Conveyor Belt
When replacing a damaged or worn conveyor belt, always
inspect hopper seals (Fig. 23) and gate edge (Fig. 23) for
wear or torn edges. Replace worn or torn components to
insure proper operation of new conveyor belt.
1
1. Hopper seal
2. Gate edge
1. Remove chain cover, spacer and finger guard (Fig. 24).
2
1. Chain cover
2. Finger guard & spacer
2. Remove master link from chain and remove chain from
small sprocket (Fig. 25).
16
1
2
1
1