Connection With Spp-Profile - Pepperl+Fuchs ECOM Ident-Ex 01 Operating Instructions Manual

Lost connection:
If the Ident-Ex 01 has lost the connection (e.g. out of range), the Ident-Ex 01 will
try to connect to the device approx. every 5 seconds until the connection was
made or the Ident-Ex 01 was switched off.
Disconnect / start new connection:
The connection of the Ident-Ex and the device (Bluetooth LED illuminating) can
be terminated by pressing the SPP Button for approx. 2 seconds.
If the Ident-Ex 01 is not connected with a device (Bluetooth LED off) and the SPP
Button is pressed for approx. 2 seconds, the Ident-Ex 01 tries to connect to the
last connected device. If no connection can be established and the SPP Button
is pressed further, the Ident-Ex 01 tries to connect to the next of the 5 saved
connection every 5 seconds (only if SPP Button pressed).
Advice:
If you are using the Ident-Ex 01 with a Android device in HID-Profile, it is possible
that the Soft-Keyboard of the operating system can't be activated, for further
information's see„19 CamScan Keyboard APP".

17. Connection with SPP-Profile

To start a connection with SPP-Profile, the connection has to be established
from the input device. The connection will be shown as COM-PORT on the PC.
Use this COM-PORT to communicate with the Ident-Ex 01. To start a connection
with SPP-Profile, the SPP and Bluetooth LED have to be off, otherwise no suc-
cessful connection can be established.
Connecting:
To connect in SPP-Profile, the input device has to start a connection inquiry
(open connection with COM-PORT). The SPP and Bluetooth LED will illuminate if
a successful connection was established. If only the Bluetooth LED is illumina-
ting, disconnect (see "Disconnect") and start a new connection. See Software
Manual (DOCT-7016) for more detailed information's.
Disconnect:
The connection of the Ident-Ex and the device can be terminated by pressing the
SPP Button for approx. 2 seconds until the SPP and Bluetooth LED goes out. Af-
ter disconnect the SPP connection, the Ident-Ex 01 tries to connect in HID-Pro-
file with the last device. The Bluetooth LED will illuminate if the HID connection
was successful.
7