Reading With A Head Module; Bluetooth Pairing Of Ident-Ex; Connection With Hid-Profile - Pepperl+Fuchs ECOM Ident-Ex 01 Operating Instructions Manual

Bluetooth scanner

Table of Contents

Settings, such as the selection of the head module and the selection of the

module which reacts by pressing the Main Trigger or Trigger, will not be part of

the reset.

14. Reading with a head module

The head module which shall be used for reading can be chosen through the

settings. Also, the button which starts the reading of the head module can be

selected. The selected button starts the reading and sends the data with the

Bluetooth connected device.

While reading, the Scan LED blinks. When the reading was successful, the Scan

LED lights up for a defined timeperiod "setting in the Software Manual DOCT-

7016" and an accustic signal rings. (Can be deactivated through settings of

Ident-Ex => "Enable Beep")

Switch on the Ident-Ex 01 to pair it with a device. The SPP and Bluetooth LED

must not illuminate. If the Bluetooth LED is illuminating, press the SPP Button

for approx. 2 seconds until the Bluetooth LED goes off.

Pairing with a PC:

Chose the Bluetooth name of the Ident-Ex 01 through "Start" -> "System control"

-> "Hardware and sound" -> "add Bluetooth device"

Pairing with a Smartphone or Tablet:

Chose the Bluetooth name of the Ident-Ex 01 through "Settings" → "Bluetooth"

Now, the device is paired with the Ident-Ex.

No pairing password is required because of the SSP-Mode

(Secure Simple Pairing) of the Ident-Ex 01.

Autoconnect:

After switching on the Ident-Ex 01, the Ident-Ex 01 will automatically try to

connect with the last connected device with HID-Profile. The automatically

connecting process after start-up can be switched on/off in the settings (see

"HID autoconnect" setting in the Software Manual DOCT-7016).

Table of Contents