Storage Precautions; Remove The Integrated Battery - Philips Avent SCD843 Manual

26
English
Storage

Storage precautions

Disposal

Remove the integrated battery

When you are not going to use the baby monitor for a long time, store the
parent unit, the baby unit and the adapters in a cool and dry place.
-
Do not expose the baby unit and parent unit to extreme cold or heat or
to direct sunlight.
-
Do not put the baby unit and the parent unit close to a heating source.
This product may contain lead and mercury. Disposal of these materials
may be regulated due to environmental considerations. For disposal
or recycling information, please contact your local authorities or visit
www.recycle.philips.com.
Note: We strongly advise you to have a professional remove the
rechargeable battery.
Only remove the rechargeable battery when you discard the appliance.
Make sure the battery is completely empty when you remove it. Only the
parent unit includes a battery.
Procedure:
1 Remove the 2 rubber feet at the bottom of the parent unit.
2 Remove the 2 screws that are now visible at the bottom of the parent
unit.
3 Put the antenna in upward position and remove the screw in the back
housing that is now visible.
4 Remove the back housing from the front housing by forcing a screwdriver
in between them. For newer versions manufactured after August 2020*,
there are 2 more screws underneath the rating label. Tear out the rating
label, remove the screws, release the belt clip and slide open the battery
compartment door.
5 Disconnect the battery connector cable (black-white-red cable).
6 Remove the 4 screws from the battery holder. No screws for new versions
manufactured after August 2020.
7 Remove the battery.
*The production date code DDMMYY is located underneath the belt clip,
above the 2 rubber feet.
If there is no collection/recycling system for electronic products in your
country, you can protect the environment by removing and recycling the
battery before disposing the product.
Make sure the product is disconnected from the charging case before
removing the battery.