Installation - Everbilt SP03302VD Use And Care Manual

Installation

CAUTION: Always use the handle to lift the pump. Never use the power cord to lift the pump. To avoid skin burns, unplug the pump
and allow time for it to cool after periods of extended use.
1
Installing the adaptor
For 1-1/2 in. pipe installation, wrap the threads of the 1-

1/2 in. pipe with thread tape.
For 1-1/4 in. pipe installation, wrap the thread of the 1-1/4

in. adaptor (B). Screw the adaptor on the pump discharge.
Wrap the threads of the 1-1/4 in. pipe with thread tape.
NOTE: If the discharge pipe has thread, you can thread the
pipe into the pump discharge. If the discharge pipe does not
have thread, you can thread an adaptor (thread-slip adaptor
sold separately) into the pump discharge.
3
Connecting the check valve
Slide down the sump lid.

Install a 1-1/2 in. or 1-1/4 in. check valve (not included) in

the vertical discharge pipe. Be sure the flow is away from
the pump.
Remove the cord grommet from the sump lid and pass the

power cord plug through the grommet hole.
NOTE: A check valve installation is strongly recommended.
2
Attaching the discharge pipe
connection
Attach the discharge pipe (1) to the adaptor (B).

4
Connecting the discharge pipe
Install a 90°elbow (1) (not included) and connect the pump

to the discharge pipe.
NOTE: Vertical switch is directly built in the pump. It does
not have a plug.
6