Training Mode - Sharp UP-820N Instruction Manual

TRAINING Mode

The training mode is used when the operator or the manager practices POS terminal operations.
In case "clerk and cashier system" is applied to your POS terminal, cashiers can enter to the
NOTE
training mode.
When a clerk/cashier set in training is selected, the POS terminal automatically enters the training mode,
while a clerk/cashier not set in training is selected, the POS terminal automatically enters the ordinary REG
mode. A training text and a maximum of two training clerks/cashiers can be programmed.
The training operations are valid in all modes.
A mark which is identifying a training receipt is printed on the receipt which is issued in the training mode.
The journal report completely stops in the training mode. The consecutive number is not updated. The
preceding number is repeated in printing.
The memory in clerk/cashier is updated in the training mode. Other memories are not updated.
The GLU codes which are opened in the training mode are also printed on the GLU report. In this case,
those GLU codes are distinguished from others by the character of "T." The data of training GLU codes are
not added to the total.
The reading and resetting of training clerks/cashiers is printed on the clerk/cashier reports. However, the
sales total of training clerks/cashiers is not included in the clerk/cashier total on the full clerk/cashier report.
Selecting the
clerk set in
training
Key operation
5
x
3
3
c
Print
103