Image Send Settings; Fax Settings; Fax Default Settings; Remote Reception Number Setting - Sharp MX-C381 Operation Manual

Image Send Settings

Settings related to the image send function (scan, Internet fax, etc.) can be configured. Touch the [Image Send Settings]
key to configure the settings.

Fax Settings

Fax Default Settings

The fax settings can be enabled or disabled to suit the
needs of your workplace.
Auto Wake Up Print
When the [POWER] key (
power switch is "on") and a fax is received, this function
automatically activates the machine and prints the fax.
When this function is disabled, received faxes are not
printed until the [POWER] key (

Pause Time Setting

Use this to change the length of pauses inserted in fax
numbers.
If a hyphen "-" is entered when dialling or storing a fax
number, a pause of 2 seconds is inserted.
The pause can be changed to any number of seconds
from 1 to 15.
* Note that in South Africa, the machine is normally set
to 4 seconds.
Fax Dest. Confirmation Mode
This setting specifies whether or not a destination
verification message is displayed when sending a fax in
order to prevent accidental transmission to the wrong
destination.
) is "off" (but the main
) is switched "on".
Speaker Settings
Use these settings to set the sound heard from the
speaker for the Speaker, Ringer Volume, Line Monitor,
Fax Receive Complete Signal, Fax Send Complete
Signal, and Fax Communication Error Signal. For the
Fax Receive Complete Signal, the Fax Send Complete
Signal, and the Fax Communication Error Signal, the
Tone Pattern and Transmission Complete Sound Time
Setting can be selected in addition to the volume.
Check on Setup Sounds
Use this to check the selected tone pattern and volume.

Remote Reception Number Setting

Fax reception can be activated from an extension phone
connected to the machine by entering a 1-digit number
and pressing the
This number is called the remote reception number, and
you can set it to any number from "0" to "9".
Original Print on Transaction
Report
When a transaction report is printed for a memory
transmission, this is used to print part of the first page of
the transmitted original on the transaction report. Select
one of the settings below.
• Print Out All Report
• Print Out Error Report Only
• No Printed Report
This setting will not be effective if
Print Select Setting" below is set to "No Printed Report".
7-102
SYSTEM SETTINGS
key twice on the phone's keypad.
"Transaction Report
Contents