Sharp MX-C380 Quick Start Manual page 77

(6) key /
When "Hold Setting for Received
Data Print" or "Received Data
Image Check Setting" is enabled in
the system settings (administrator),
this will appear when a fax is
received.
: Only "Hold Setting for
Received Data Print" is
enabled
: Only "Received Data Image
Check Setting" is enabled
: Both settings are enabled
(7) [Sub Address] key
Select this key to enter a
sub-address and passcode for
F-code transmission.
(8) [Speaker] key / [Pause] key /
[Space] key
Select this key to dial using the
speaker.
When entering a fax number to be
dialled, the key changes to the
[Pause] key. When entering a
sub-address, the key changes to
the [Space] key.
(9) [Resend] key / [Next Address]
key
The destinations of the most recent
eight transmissions by Scan to
E-mail, fax and/or Internet fax
(including Direct SMTP addresses)
are stored. Select the [Resend] key
to send to one of these addresses.
After a destination is selected, this
key changes to the [Next Address]
key.
key / key (10) This shows the currently
selected fax reception mode and
the amount of free memory
remaining.
(11) [Exposure] key
Select this key to specify the
exposure for scanning.
(12) [Resolution] key
Select this key to select the
scanning resolution.
(13) [Special Modes] key
Select this key to use a special
mode.
(14) [Direct TX] key
Select this key to send a fax by
direct transmission. When the
[Direct TX] key is not highlighted,
normal transmission (memory TX
mode) is selected.
75