The Transmitted Fax Prints Out Blank At The Receiving Side; The Transmitted Fax Is Reduced By The Receiving Fax Machine; Transmission Does Not Begin At The Specified Time; Problems Related To Reception - Sharp MX-7001N Safety Manual

Problem
Transmission does
not take place.
The transmitted fax
prints out blank at the
receiving side.
The transmitted fax is
reduced by the
receiving fax machine.
Transmission does
not begin at the
specified time.

Problems related to reception

Problem
Printing does not take
place after reception.
Point to check
Did you place a long size original on the
document glass when it is scanned?
Did you place an original that is folded?
Are the sub-address and passcode
correct?
(When using F-code communication)
Have functions been disabled by the
administrator?
Is the original placed face up or face
down correctly?
If the receiving machine is using thermal
paper, was the thermal paper loaded
with the wrong side out?
Has image rotation been enabled?
Is the machine's clock set to the correct
time?
Is a transmission in progress?
Point to check
Does a message appear in the display
instructing you to add toner or paper?
(Printing is not possible when this
screen appears.)
Solution
A long size original cannot be scanned from the
document glass. Place originals in the document feeder
tray of the automatic document feeder.
If a folded original is placed in the automatic document
feeder, an error will occur and scanning will be
cancelled when the actual original size is detected
during scanning.
Following the instructions in the display, unfold the
original, place it in the automatic document feeder
again, and rescan.
Check with the operator of the other machine to make
sure that the sub-address and passcode are correct.
When user authentication is enabled, the functions that
you can use may be restricted in your user settings.
Check with your administrator.
When using the document glass, the original must be
placed face down. When using the automatic document
feeder, the original must be placed face up. Place the
original correctly and send the fax again.
Check with the operator of the other machine.
When "Rotation Sending Setting" is not enabled (the
image is not rotated), an original placed in the vertical
orientation may be reduced by the receiving machine.
Enable "Rotation Sending Settings" before
transmission.
➞ System Settings (Administrator) > "Image Send
Settings" > "Fax Settings" > "Fax Send Settings" >
"Rotation Sending Setting" >
Set the clock to the correct time.
➞ System Settings > "Default Settings" > "Clock" >
"Clock Adjust"
If another transmission is in progress when the specified
time arrives, the timer operation will begin after that
transmission is finished.
Solution
Restore printing capability as instructed by the
message.
43