Pc Software Obelisk Top2 - Theben SELEKTA top2 Series Manual


Since this has activated a new switching program, any set MANUAL switching is deleted.

Press a button on the time switch to end the execution of the program on the OBELISK top2
memory card. After displaying ABORT, the system returns to the OBELISK menu and START
OBELISK PROGRAM is displayed.

In the case of an activated OBELISK PROGRAM, the switch commands are executed from
the OBELISK top2. All time switch settings (date format, time format, etc. ) remain unchanged
and cannot be changed in SELEKTA top2 time switches with the OBELISK top2 memory card
either.

If the OBELISK top2 is disconnected during the execution of the OBELISK PROGRAM, the
program is ended. After displaying ABORT, the system changes to the normal auto mode and
returns to the switching program saved in the time switch.

It is also possible to execute an OBELISK PROGRAM with ALWAYS OFF (no switching times
or only an OFF switching time is saved). By inserting this OBELISK top2 memory card and
starting the OBELISK PROGRAM, it is possible to suppress the execution of the switch
commands saved in the time switch.

12.5. PC software OBELISK top2

In the download area of the Theben homepage www.theben.de, the PC software OBELISK top2 is
available for download free of charge.
Using the OBELISK top2 software, it is possible to easily create switching programs for the time
switches on a PC, save them as a project and transfer them to the time switches via the OBELISK
top2 memory card.
Software support is available by selecting the item "OBELISK top2 help" under "Help" in the OBELISK
top2 software or directly by pressing the F1 button.
Note on the graphical programming of IMPULSE and CYCLE: When programming the impulse and
cycle times, it must be ensured that the impulse duration or pulse and pause duration are always
entered in the table, otherwise "Program contains errors" is shown (see figure, red circles).
Page | 79