IBM Netfinity 10/100 Ethernet Adapters Installation Manual page 20

Figure 3. Connecting the 2-Way Wake On LAN Cable
10. Connect a twisted-pair Ethernet Category 5 cable to the adapter and to your
11. Switch ON the connected devices and the computer.
4
Netfinity 10/100 Ethernet Adapters: Installation Guide
3. Place the adapter in the slot.
Note: Most PCI slots in computers are Busmaster-enabled, but some are not.
If you have configuration problems, refer to your computer manual.
4. Push the adapter into the slot until the adapter is seated firmly. Secure the
adapter bracket with a screw.
5. Locate the Wake On LAN connector on your system board. The location
varies, depending on the vendor and model. The connector is usually located
near other power connectors, such as the LED connectors.
6. Connect the other end of the cable to the connector on the system board as
shown in Figure 3.
7. Some computers might require you to change a setting in the BIOS or setup
program to enable the Wake On LAN feature. Check your computer manual or
contact your dealer for more information.
8. If you are installing more than one adapter, repeat steps 6, 7, and 8 on page 2
for each adapter that you want to install.
Otherwise, continue with step 9.
Note: In the U.K., by law, the power cord must be connected before the
telephone line cable.
9. Replace the cover on the computer, connect the cables to the connected
devices, connect the signal cables to the receptacles, and then connect the
power cord to the outlet.
Ethernet outlet. See "Using the Correct Adapter Cable" on page 2 for more
information.