Table of Contents
Advertisement
3. Place the label roll on the Label Supply
Spindle and then flip the Label Roll Guard
upwards to hold it in place.
Note
•
Make sure the label print side is
facing up.
•
To detect the remaining amount of
the media in the label roll, slide the
Media Level Sensor up.
4. Push the Print Head Release Lever and
thread the label through the Media Guide
Bar, Damper, Media Sensor, and Front
Label Guide to install the media. Align the
Label Roll Guard with the label width.
5. Move the Media Sensor by adjusting the Media Sensor Position Adjustment Knob. Make sure
the position of the Gap or Black Mark Sensor matches the position of the Gap/Black Mark on
the label roll.
37
Black Mark Sensor
(shown as
)
Gap Sensor
(shown as
)
Advertisement
Table of Contents
