Table of Contents
Advertisement
5. Feed the media through the Label Cutter
Cover Slot.
6. Move the Media Sensor by adjusting the Media Sensor Position Adjustment Knob. Make sure
the position of the Gap or Black Mark Sensor matches the position of the Gap/Black Mark on
the label roll.
7. Adjust the Front Label Guide to fix the
media position.
Note
•
Make sure you thread the media
through the Media Sensor.
•
The sensor locations are marked by
the triangle mark
and the arrow mark
Sensor) at the sensor housing.
•
The Media Sensor position is
adjustable. Make sure the position of
the Gap or Black Mark Sensor
matches the position of the
Gap/Black Mark on the label roll.
(Gap Sensor)
(Black Mark
34
Black Mark Sensor
(shown as
)
Gap Sensor
(shown as
)
Advertisement
Table of Contents
