Table of Contents
Advertisement
Chapter 6
Maintenance
Install or Replace
Components
126
The procedures in this section describe how to install or replace system
components.
The iTRAK 5730 motor modules and safety-related system do not contain
IMPORTANT
serviceable parts. No repair option is provided in the event of a motor module
defect. In the case of a failure, replace the motor module.
Replacement Hardware
All hardware removed for service must either be replaced with new hardware
IMPORTANT
from kit catalog number 2198T-BE-KITCON or have thread lock (such as Loctite
243) applied to the threads before hardware is reinstalled.
Thread patches and thread lock can become worn during disassembly and will
not function correctly if not replaced. Kit catalog number 2198T-BE-KITCON
contains rail kit components that can be used to replace worn hardware.
2198T-BE-KITCON Contents
Component
M4 x 8 mm Torx screws
M4 x 20 mm Torx screws
Rectangular rail wedge
Flat rail wedge
For a complete list of tools and accessories required for performing these
procedures, see
Tools and Accessories
Procedure
Install or Remove a Position Magnet Assembly
Install or Replace a Mover
Replace a Straight Motor Module
Replace a Curved Motor Module
Replace Top and Bottom Rectangular Straight Rails
Replace Top and Bottom Rectangular Curved Rails
Replace Top and Bottom Flat Straight Rails
Replace Top and Bottom Flat Curved Rails
Replace Top and Bottom Rectangular Wedges
Replace Top and Bottom Flat Wedges
Replace a Connector Module
Replace an Infield Cover
Rockwell Automation Publication 2198T-UM003A-EN-P - May 2020
Quantity
20
28
2
2
on page 38.
Page
127
128
134
139
142
143
145
147
149
150
152
153
Advertisement
Table of Contents
