Install Power Supply; Install 1775 P3 Power Supply Into The Plc 3/10; (Or Single Chassis Plc 3) - Allen-Bradley PLC-3 Series Quick Start Manual

Install Power Supply

Install 1775 P3 Power Supply into the PLC 3/10

(or single chassis PLC 3)

a
Install the dc power cable.
PLC 3/10 chassis
backplane
CF1
Squeeze the side tabs of the plugs
as you connect them to the backplane.
Plug the cable assembly into the connectors on the power supply module,
b
connect the 8 pin control connector cable to the power supply module, and
insert the power supply module in the right most slot of the chassis.
1775 P3
power supply
P2
P1
module
Squeeze the side tabs of the plugs
as you connect them to the module.
Feed the dc power cable under the
module guides along the backplane.
CF2
20417 M
Connect the cable
at the 8 pin connector.
When you install the 1775 P3 power supply into a PLC 3/10, if
there is a jumper plug (PN 967447 01) installed on the
8 pin control connector terminals, remove and discard it.
PLC 3/10 chassis
2
Step
Insert and tighten all six screws
on the outside of the chassis.
20418 M
Publication 1775 10.1 - March 1996