Siemens Simatic ET 200SP Manual page 26

6. Insert and fasten the BusAdapter BA-Send 1xFC with the BaseUnit BU-Send (1 screw with
tightening torque of 0.2 Nm). To do this, use a screwdriver with a 3 to 3.5 mm blade.
7. Connect the M8 connector of the bus cable to the first ET 200AL I/O module (socket X30
ET-Connection IN). For more information about wiring the ET 200AL I/O modules, refer to
the system manual of the ET 200AL distributed I/O system.
① Locking slide
② Cable routing
Figure 6-4 Connection of the BusAdapeter BA-Send 1xFC
Mixed configuration
Equipment Manual, 11/2020, A5E33344611-AD
③ Shield contact
④ Bus cable for ET-Connection
Connecting
6.1 Connecting BaseUnit BU-Send
25