Indicating (Marking) The Indoor And Outdoor Unit Combination Number - Panasonic Inverter R32 Series Technical Data & Service Manual

2-9. Indicating (marking) the indoor and outdoor unit combination number

Indicate (mark) the number after auto address setting is completed.
● So that the combination of each indoor unit can be easily checked when multiple units are installed, ensure that the indoor and
outdoor unit numbers correspond to the system address number on the outdoor unit control PCB, and use a magic marker or similar
means which cannot be easily erased to indicate the numbers in an easily visible location on the indoor units (near the indoor unit
nameplates).
Example: (Outdoor) 1 - (Indoor) 1
(Outdoor) 2 - (Indoor) 1
● These numbers will be needed for maintenance.
Be sure to indicate them.
Use the remote controller to check the indoor unit address.
High-spec Wired Remote Controller (CZ-RTC5A / CZ-RTC5B)
(1) Keep pressing the
simultaneously for 4 or more seconds.
The "Maintenance func" screen appears on the LCD
display.
Maintenance func
1. Outdoor unit error data
2. Service contact
3. RC setting mode
4.Test run
Sel. Page [
(2) Press the or
If you wish to see the next screen instantly, press the
or button.
Select "7. Simple settings" on the LCD display and press
button.
the
Maintenance func
5. Sensor info.
6. Servicing check
7. Simple settings
8. Detailed settings
Sel. Page [
Timer remote controller (CZ-RTC4)
<If 1 indoor unit is connected to 1 remote controller>
(1) Press and hold the
seconds or longer (simple settings mode).
(2) The address is displayed for the indoor unit that is
connected to the remote controller.
(Only the address of the indoor unit that is connected to
the remote controller can be checked.)
(3) Press the button again to return to normal remote
controller mode.
, and buttons
20:30 (THU)
] Confirm
button to see each menu.
20:30 (THU)
] Confirm
button and button for 4
(3) The "Simple settings" screen appears on the LCD display.
Select the "Unit no." by pressing the
button for changes.
Simple settings
Unit no.
3-1
Sel.
The indoor unit fan operates only at the selected indoor unit.
[ ]
START
2-9
or
20:30 (THU)
Code no. Set data
01 0001
Next
20:30 (THU)
Number changes to indicate
which indoor unit is currently
selected.
Indoor unit address
2