1
How to connect wiring to the terminal
■ For stranded wires
(1) Cut the wire end with cutting pliers, then strip the insulation
to expose the stranded wire about 10 mm and tightly twist
the wire ends.
Stranded wire
(2) Using a Phillips head screwdriver, remove the terminal
screw(s) on the terminal board.
(3) Using a ring connector fastener or pliers, securely clamp
each stripped wire end with a ring pressure terminal.
(4) Put the removed terminal screw through the ring pressure
terminal and then replace and tighten the terminal screw
using a screwdriver.
Special
Screw
washer
Ring pressure
terminal
Wire
■ Assembling parts for outdoor unit cover
Cord clamp A
Cord clamp D
Ring
pressure
terminal
Screw and
Special washer
Terminal board
Ring
pressure
terminal
Wire
Terminal board
Earth
Cord clamp C
Terminal cover
Cord clamp B
Pipe cover
Screw
1-10-4