Assembly Step - Horizon Fitness 7.8 AT Owner's Manual

ASSEMBLY STEP 1

PART TYPE
A UPRIGHT GUIDE BOLT
B MAST BOLT
C FLAT WASHER
D SPRING WASHER
2
4
1
A
C
D
10
B
HARDWARE FOR STEP 1
DESCRIPTION
M8X1.25PX11L
M8X1.25PX80L
8.4X15.5X1.6T
8.2X15.4X2.0T
7
4
B
D
C
A
3
A Cut the yellow banding straps and lift the running deck
upward from the rear to remove all contents from
QTY
underneath the running deck.
2
B Open HARDWARE FOR STEP 1.
8
Insert UPRIGHT GUIDE BOLT (A) into MAIN FRAME
C
8
BRACKET (1) and fully tighten.
8
NOTE: Do not fully tighten the following bolts until the
end of STEP 4.
Attach LEAD WIRE to bottom end of CONSOLE
D
CABLE (2). Pull LEAD WIRE through RIGHT
CONSOLE MAST (4). After pulling the lead wire
through the mast, the top of the CONSOLE CABLE (2)
should be located at the ATTACHMENT BRACKET (7).
E Attach RIGHT CONSOLE MAST (4) to MAIN
FRAME (3) using 4 BOLTS (B), 4 FLAT WASHERS (C)
AND 4 SPRING WASHERS (D). Feed the extra console
cable back into the upright mast.
NOTE: Be careful not to pinch the console cable
while attaching the right console mast.
F Repeat STEP E on the LEFT SIDE.
A
B
C
D