Related Manuals for Vega PLICSMOBILE 80 Series
Summary of Contents for Vega PLICSMOBILE 80 Series
- Page 1 Operating Instructions Electronics module PLICSMOBILE 80 series Document ID: 57392...
-
Page 2: Table Of Contents
Dismounting steps......................10 Disposal ......................... 10 Safety instructions for Ex areas Take note of the Ex specific safety instructions for Ex applications. These instructions are attached as documents to each instrument with Ex approval and are part of the operating instructions manual. Editing status: 2018-03-15 Electronics module • PLICSMOBILE 80 series... -
Page 3: About This Document
Symbols used Document ID This symbol on the front page of this instruction refers to the Docu- ment ID. By entering the Document ID on www.vega.com you will reach the document download. Information, tip, note This symbol indicates helpful additional information. -
Page 4: For Your Safety
If the instrument comes with approvals, the associated approval documents of the sensor must always be noted. They are included with the delivery but can also be downloaded under "www.vega.com", "Instrument search" as well as via "Downloads" and "Approvals". Environmental instructions Protection of the environment is one of our most important duties. -
Page 5: Product Description
Not exposed to corrosive media • Protected against solar radiation • Avoiding mechanical shock and vibration • Storage and transport Storage and transport temperature see chapter "Supplement - temperature Technical data - Ambient conditions" Electronics module • PLICSMOBILE 80 series... - Page 6 3 Product description • Relative humidity 20 … 85 % Electronics module • PLICSMOBILE 80 series...
-
Page 7: Mounting
Make sure that you are using a replacement electronics suitable for the instrument. The electronics modules differ: • Ex and non-Ex Installation procedure Proceed as follows: 1. Switch off power supply 2. Unscrew the lid of the electronics compartment Electronics module • PLICSMOBILE 80 series... - Page 8 13. Insert the SIM card according to the operating instructions manual of the respective instrument 14. Screw the housing lid back on The electronics exchange is now finished. As a rule, an exchange of electronics must be documented internally if Ex applications are involved. Electronics module • PLICSMOBILE 80 series...
-
Page 9: Setup
While accessing via DTM, the access codes must be thus entered once new. With a VEGA Inventory System connection also the net- work access code must be updated in the VEGA Inventory System. For this, you have to contact your responsible contact person. -
Page 10: Dismount
Pass the instrument directly on to a spe- cialised recycling company and do not use the municipal collecting points. These may be used only for privately used products according to the WEEE directive. Electronics module • PLICSMOBILE 80 series... - Page 11 Notes Electronics module • PLICSMOBILE 80 series...
- Page 12 Subject to change without prior notice © VEGA Grieshaber KG, Schiltach/Germany 2018 VEGA Grieshaber KG Phone +49 7836 50-0 Am Hohenstein 113...