Symbols used Document ID This symbol on the front page of this instruction refers to the Docu- ment ID. By entering the Document ID on www.vega.com you will reach the document download. Information, note, tip: This symbol indicates helpful additional infor- mation and tips for successful work.
2 For your safety For your safety Authorised personnel All operations described in this documentation must be carried out only by trained, qualified personnel authorised by the plant operator. During work on and with the device, the required personal protective equipment must always be worn. Appropriate use Electronics module, emitting electronics, housing or process compo- nents are replacement components for existing sensors.
3 Product description Product description 3.1 Configuration Scope of delivery The scope of delivery encompasses: • Process module • Documentation – This operating instructions manual Principle of operation Application area The process component is suitable as replacement unit for the follow- ing sensors: •...
4 Mounting Mounting Mounting preparations Tools The following tools are required for dismounting the existing and mounting the spare process component: • Magnetic screwdriver Torx size T10 or slot 4 • pliers for locking ring (version axle) • Screwdriver, slot size 1 •...
Page 7
4 Mounting 2 (-) Fig. 3: Loosen the holding screws Electronics module Screws (2 pcs.) 5. Pull the electronics out by holding the opening levers. Remove the housing Proceed as follows: 1. Loosen the screws of the limit bracket and the locking ring with a Phillips screwdriver size 1 Fig.
4 Mounting Fig. 5: Double chamber housing Position of the screw 4. Remove the housing Mounting steps new process component 1. Place the housing onto the new process component. 2. Depending on the housing, tighten the locking screw on the base with a screwdriver 3.
5 Setup Setup Setup Setup is carried out according to the operating instructions manual of the respective sensor. Process module • VEGABAR series 80...
6 Dismount Dismount Dismounting steps Take note of chapters " Mounting" and " Connecting to voltage sup- ply" and carry out the listed steps in reverse order. Disposal Pass the instrument on to a specialised recycling company and do not use the municipal collecting points.
7 Supplement Supplement Technical data Technical data are stated in the operating instructions manual of the respective sensor. Process module • VEGABAR series 80...
Page 12
Notes Process module • VEGABAR series 80...
Page 13
Notes Process module • VEGABAR series 80...
Page 14
Notes Process module • VEGABAR series 80...
Page 15
Notes Process module • VEGABAR series 80...