Accessory - Dantherm HCC 260 P1 Service Manual

Accessory

Introduction
Electric preheating
Hand held Remote
control
Wired Remote
Control
(HCP 10/11)
Accessory control
(HAC 2)
VOC and humidity
sensors
Filters
10
The unit is delivered from factory, without any accessories mounted. These are to be installed
prior to initial unit installation or alternative after commissioning, if further functionality is
requested. The detailed installation of one or more accessories, is illustrated on the leaflet fol-
lowing each accessory .
The unit can be fitted with an electrical preheating element that preheats the incoming air.
The preheater increases the outside air temperature going into the heat exchanger, and
thereby reduces the risk of ice in the heat exchanger in very cold conditions.
The preheater is an external enclosure, connected and controlled by the HCC 260/360 con-
troller.
For controlling HCC 260/360
units, Dantherm recommends us-
ing remote control, designed for
this range of units.
A wired remote control (HCP 10/11) without display can be
connected to the unit as an alternative to the hand held remote
control.
Connect a number of additional accessories to the
HCC 260/360 unit via an accessory controller: HAC 2.
HCC 260/360 can be fitted with Humidity (RH%) (if not al-
ready included as standard) and/or VOC (organic chemi-
cals) sensors. These sensors will continuously monitor
the extract air, and adjust the air flow level accordingly.
This will result in adequate level of ventilation, with low-
est possible electrical power consumption. If a remote
control is connected, the sensor level will be shown in
the display using 3 level icon.
Replacement of filters in sets of 2 ISO Coarse filters or 1 ISO Coarse plus 1 ePM1 (pollen) filter.
Product description: Accessory
AUTO
* *
CO

2
°
RH%  °
°
Fig. 5
RH%
°
Ikoner for manual
Fig. 6
Fig. 7
VOC
Fig. 8